Villager VLN 1315, Инструкция по эксплуатации

Страница: 25 / 118

Villager VLN 1315 (GB)
11
e. Use
Be careful of hidden electrical lines or gas and water pipes. Check the working
area, e.g. with a metal detector.
Check the product, power cord and plug as well as accessories for damage before
each use. Do not use the product if it is damaged or shows wear.
Double check that accessories or application tools are properly fixed.
Always hold the product by its handles. Keep handles surfaces clean and dry to
ensure safe support.
Ensure that the air vents are always unobstructed and clear. Clean them if
necessary with a soft brush. Blocked air vents may lead to overheating and
damage the product.
Switch the product off immediately if you are disturbed while working with it and
when other people enter the working area. Always let the product come to a
complete stop before putting it down.
Do not overwork yourself. Take regular breaks to ensure concentrated work and
full control over the product.
- Plug the tool to the supply mains.
- Apply the tip of the bit on the tool to be worked.
- Push the trigger switch to start the operation.
- In some cases, it is necessary to punch the tip of the bit against the object being
worked on in order to begin the striking stroke. This is not due to malfunction of
the power tool. It means that the safe guard mechanism against no-load striking
is working.
- Operate this demolition hammer by utilizing its own weight.
- Switch off and unplug the tool after the end of the operation.
The performance will not be better even if it is pressed or thrust forcibly against
the work surface. Hold this demolition hammer with a force just sufficient to
counteract the reaction force
f. Grease replacement
This tool is of full air-tight construction to protect against dust and to prevent
lubricant leakage. This machine can be used without grease supplement for an
extended period of time. However, perform the grease replacement to maintain
the service life. Replace the grease as described below:
-
Check the quantity of grease and when you change the carbon brush.
- Use the provided lubricant tube. If finish, use a recommended lubricant. See your
dealer for advice.
The tool must be switched off and unplugged before the replacement.
- Open the crank cover with the provided wrench.
- Wipe off the old grease inside.
- Put the grease into the crank case. Do not overfill