Villager Villybot 2.0, Оригинальное руководство пользователя, Страница: 43 / 272

12
Please note: When installing the wire around the perimeter of pond of water, the distance
between the wire and the edge of the pond must be more than 75 cm, for safety reasons.
In case there is a power cut your robotic lawnmower will stop after not noticing the wire
for 50 cm on slope terrain.
Please note: When marking objects (bushes etc.) remember there must be at least 75 cm
distance between two objects. Leaving less distance than this will cause interference.
Please note: Do not install the wire on the slope (max 17° or 30%), or your mower could slip
out the boundary easily.
Encircling obstacles
Mark out permanent objects you do not want the mower to run over, e.g. roots, ponds,
flowerbeds or rocks. This will prevent your robotic lawnmower colliding with objects or
going straight into them.
To mark a obstacle:
a)
Run the wire from the lawn perimeter to the object.
b) Continue round the objects in a clockwise direction. When going around the object use
more pegs. So they are closer than 100 cm.
c) Return the wire back to the perimeter. Ensure the distance from the wire around the
object and lawn perimeter is at least 75 cm.
Please ensure that the two parallel wires leading from encircled object to perimeter are as
close as possible by placing the wire under the same peg. This will make the wire
undetectable to your robotic lawnmower. Please ensure that the wires do not cross over
each other at any point. (Figure 12)
Please note: Remember to leave 30 cm around the object to the wire! If objects are less
than 75 cm from the lawn edge, surround the object when installing the wire, leaving the
object outside of the lawn cutting area.
Please note: The wire must be set close to the surface of the lawn.