Villager TERRA 12, Руководство пользователя, Страница: 21 / 102

Villager TERRA 12 (GB)
To prepare the sprayer for operation, you need to pull the handle (seesaw), back and
forth, in order to create the pressure needed for the sprayer to operate (Picture 26).

Check if the flow regulator is open;

In order to create pressure within the sprayer, you need to pump it to
create impedance (6-8 times);

Spray by pressing the switch;

Adjust the sprayer by turning the front ring;

After using the sprayer release the air by pulling out the safety switch;

After using the sprayer wash it carefully with water;

User must always ask for instructions on using the substance for spraying
plants;

Never open the sprayer while under pressure;

Do not expose the sprayer to heat or sunshine.
ATTENTION! Water used during spraying must be clean, with no sand or other
abrasive particles, because those can damage parts of the sprayer and thus reduce
pressure. Any defect caused by this does not apply to the warranty conditions.
While operating the sprayer one needs to follow following precaution measures:

Do not fill the sprayer with oil, gasoline, dilution, acid, bases, resin mass;

Do not spray during windy weather or temperatures below 0
o
C;

After usage wash the sprayer, and then wash the protective agents and
hands.

Do not use a spray if you feel tired.

Do not use a spray if you are under the influence of alcohol, drugs and
other medicines.

Spray is recommended in the direction of wind blowing ("down the wind")
The warranty does not apply if the malfunction was caused by incorrect usage,
handling, or a mechanical defect.