Disassembly
30
©2012 Viking Preferred Service
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Oven Function Selector Removal
1. Access control components (see Control
2. Disconnect connector from the oven function
selector.
3. Remove screws, bezel, and oven function selector
from control panel.
4. Reverse procedure for installation.
Oven Thermostat Removal
1. Access control components (see Control
2. Disconnect connector from the oven thermostat.
3. Remove screws, bezel, and thermostat from control
panel.
4. Reverse procedure for installation.
Indicator Light Removal
1. Access control components (see Control
2. Disconnect connectors from the indicator light.
3. Press both tabs in and push indicator light out from
control panel.
4. Reverse procedure for installation.
Oven Light Switch Removal
1. Access control components (see Control
2. Mark and disconnect connectors from light switch.
3. Remove screws and oven light switch from control
panel.
4. Reverse procedure for installation.
Door Switch Removal
1. Access control components (see Control
2. Remove screws and door switch from range.
3. Mark and disconnect connectors from door switch.
4. Reverse procedure for installation.