Viking Professional VUC181, Сервисный журнал

Страница: 11 / 21

12
SWITCHES-CONTROL PANEL (Fig.18)
[Filter switch (1), Key lock switch (2)]
1 Remove control panel.
2 Remove lead wires from switches.
3 Remove filter switch by depressing tabs
together and pulling switch out of panel.
4 Remove key switch, retaining nut and
then the switch.
CAUTION: Leak wire identifications
MUST correspond with switch terminals.
ELECTRICAL POWER CORD
1. Remove L.H. side panel.
2. Remove back panel.
3. Remove ground screw, wire connector
from white neutral lead and disconnect
two switch terminal connections from
drawer front interlock and bypass
interlock switch.
4. Remove strain relief bushing from left
front vertical frame upright.
5. Remove electrical power cord.
6. When reinstalling electrical power cord,
feed cord through cord clamps.
DIRECTIONAL SWITCH (Fig.18)
1. Remove top and top frame cover plate.
2. Disconnect lead wires from switch (3).
CAUTION: At reassembly, lead wire
identification MUST correspond with switch
terminals.
3. Remove switch retaining screws and the
switch.
DRAWER FRONT INTERLOCK SWITCH
1. Remove top and left side panel.
2. Remove interlock switch lead wires.
3. Remove switch mounting screws and
the switch.