16
Description of the hood & Controls
1
Control panel
2
Grease filter (Behind the panel)
3
Grease filter release handle
4
Halogen lamp (Position and number of lamps may vary)
5
Hood canopy
6
Duct cover
7
Louver holes (Ductless configuration)
8.
Panel
Controls
Description of control panel
To select the functions of the hood just touch the
commands.
Light key ON/OFF
Intensive speed selection key
(suction power) -
duration 5 minutes - press again to return to previous
setting.
High-speed selection key
(suction power).
Medium-speed selection key
(suction power) -
when flashing it indicates the need to wash or replace
the carbon filter. This signal is normally deactivated.
To activate the alarm, disable the electronic by
pressing the
0
button for 3 seconds.
Next, simultaneously press buttons
1
and
2
for 3
seconds; at first, only button
1
will flash, then both
buttons
1
and
2
will flash to indicate activation.
Repeat the procedure to deactivate the alarm; at first
buttons
1
and
2
will flash and subsequently only
button
1
to indicate deactivation.
Low-speed selection key
(suction power) – when
flashing it indicates the need to wash the fats filter.
Motor key OFF
(stand by) – excludes the electronics
– reset wash/replace filters signals.
MOTOR OFF
Press briefly to switch the motor off.
RESET FILTERS SIGNALS
In functioning mode, after carrying out filter
maintenance, press the key until hearing the sound
signal. The flashing LED
1
(grease filter) or
2
(carbon
filter) stops flashing.
EXCLUDING THE ELECTRONICS
Press the key for 3 seconds. The hood command
electronics will be excluded.
This function can be useful during the product
cleaning operations.
Just repeat the operation to reinsert the electronics.
If the hood fails to operate correctly, briefly disconnect it
from the mains power supply for almost 5 sec. by pulling out
the plug. Then plug it in again and try once more before
contacting the Technical Assistance Service.