4
A. Entering the Programming Mode
1. Local
2. Remote
Programming
B. Factory Default Settings
Step 1.
Move the
PROG/NORM
switch to
PROG
and plug an analog phone into the
TELCO
jack.
Step 2.
After taking the phone off hook, wait for two beeps.
Step 3.
Program as shown in sections
B-T
.
Step 4.
To exit programming, hang-up. Set the
PROG/NORM
switch to
NORM
.
Step 1.
Make sure the
PROG/NORM
switch is set to the
NORM
position and that there is a CO line or
analog PABX/KSU extension in the
TELCO
jack.
Step 2.
Call into the
K-2000-DVA
on that line or extension. The unit will answer after the set ring delay
(see
Programming
section
G
) and a single beep should be heard.
Step 3.
Enter a
Q
and the six-digit security code (factory default is
845464
). If the correct code is entered,
two beeps should be heard.
Note:
The security code must be entered within 20 seconds otherwise the
K-2000-DVA
will time
out and hang up. When in programming, if 20 seconds elapse without Touch Tones being
entered or a message being recorded, the
K-2000-DVA
will automatically exit programming and
hang up.
Step 4.
Program as shown in sections
B-T
.
Step 5.
To exit programming, hang-up. After the 20 second timeout has elapsed, the
K-2000-DVA
will
be ready for normal operation. Alternatively, dial
##7
and the
K-2000-DVA
will immediately be
ready for normal operation
Note:
Correct programming entries are implemented and then acknowledged by two beeps. Incorrect
programming entries are discarded and receive three beeps to indicate an error.
Security Code
845464 (V-I-K-I-N-G) (see section
D
Access Code
123456 (see section
F
)
Alarm Dialer Mode
Enabled (see section
E
)
Store Caster Mode
Disabled (see section
E
)
Phone Numbers
Not Programmed (see section
O
)
Messages
Not Recorded (see section
R
)
Ring Delay
1 (see section
G
)
Ringback Limit
6 (see section
H
)
Pager Number
Not Programmed (see section
P
)
Call Progress Detection
Enabled (see section
J
)
Dialing Speed
Normal (see section
I
)
Alarm Input Configuration
N/O (Enabled) Momentary (see section
K
)
Lap Counter
1 (see section
L
)
Message Repeat Counter
2 (see section
L
)
Qualifier Timer
0 - disabled (see section
M
)
Resume Timer
0 - disabled (see section
N
)
Hookswitch Flash Before Dialing
Disabled (see section
Q
)
