VIKING
©
Programmable
Tone Dialer
MODEL: K-1900-5
Quick Programming Guide
1. Call the phone connected to the dialer.
2. Answer phone. Enter
,
& security code.
(Factory set to 845464) Write your
security code below:
3. Enter your spped dial number & #00.
Note: For additional programming see
K-1900-5 Technical Practice.
Viking Electronics, Inc.
Hudson, WI 54016
LINE IN PHONE
-or-
* Earth
Ground
(optional)
(Spade
connector
included)
1
2
BUSY
RINGDOWN
DLE-200B
VIKING
©
1 2 3 4
ON
B. Wiring the K-1500-E
C. Wiring the K-1500-EHFA
* Note:
To increase surge protection, loosen the PCB mounting screw labeled (as shown above) and fasten a wire with spade terminal (includ-
ed) from the mounting screw to Earth Ground (grounding rod, water pipe, etc.)
VIKING
©
Programmable
Tone Dialer
MODEL: K-1900-5
Quick Programming Guide
1. Call the phone connected to the dialer.
2. Answer phone. Enter
,
& security code.
(Factory set to 845464) Write your
security code below:
3. Enter your spped dial number & #00.
Note: For additional programming see
K-1900-5 Technical Practice.
Viking Electronics, Inc.
Hudson, WI 54016
LINE IN PHONE
-or-
1
2
BUSY
RINGDOWN
DLE-200B
VIKING
©
1 2 3 4
ON
Rear View of the
K-1500-EHFA
DLE-200B Two Way Ringdown
Circuit (not included)
C.O. Line or analog
PABX/KSU station
programmed for
ringdown
To dedicated
phone or unused
trunk/line input
of phone system
* Optional
Viking Dialer
(not included)
C.O. Line
or analog
PABX/KSU
station
P
P
r
r
o
o
g
g
r
r
a
a
m
m
m
m
i
i
n
n
g
g
t
t
h
h
e
e
K
K
-
-
1
1
5
5
0
0
0
0
-
-
E
E
H
H
F
F
A
A
Rear View of the K-1500-EHFA
* Note:
Shown in default positions.
ON
S1
1 2 3
ON
OFF
1 2 3
DIP Switches*
Speaker Volume*
Microphone Volume*
Less (-)
More (+)
Less (-)
More (+)
Rear View of
the K-1500-E
DLE-200B Two Way Ringdown
Circuit (not included)
C.O. Line or analog
PABX/KSU station
programmed for
ringdown
To dedicated
phone or unused
trunk/line input
of phone system
Optional
Viking Dialer
(not included)
C.O. Line
or analog
PABX/KSU
station
?
Need More Information on the DLE-200B?
Call (715) 386-4345 and select 605.
A. Adjusting Speaker Volume
The
SPKR VOL
pot can be adjusted to increase or
decrease the speaker volume to the level desired as
shown right.
?
Need More Information on Hot-Line Dialers?
Call (715) 386-4345 and select 833.
?
Need More Information on the DLE-200B?
Call (715) 386-4345 and select 605.
?
Need More Information on Hot-Line Dialers?
Call (715) 386-4345 and select 833.
B. Adjusting the Microphone Volume
In certain noisy locations (background traffic, machin-
ery or wind), the microphone volume may need to be
decreased. A symptom of this is one-way talk path, in
which the distant party cannot be heard over the
speaker. A
MIC VOL
pot is provided on the
K-1500-
EHFA
for increasing or decreasing the microphone vol-
ume.
Note:
If the microphone volume is set too high
or too low, one-way talk path may occur.
C. DIP Switch Programming
DIP switch 1 is for turning the Auto Answer feature ON and OFF.
The
K-1500-EHFA
is factory set to auto answer when an inbound
call is detected.
1. Auto Answer Feature ON/OFF (DIP Switch 1)
With DIP switch 2 in the ON position, if the
K-1500-EHFA
detects
more than 5 seconds of continued dial tone, the unit will auto-
matically disconnect. If the
K-1500-EHFA
is installed on a con-
tinuously noisy line, it may detect the noise as dial tone and auto-
matically disconnect. If this happens, turn the dial tone detection
(DIP switch 2) OFF.
2. Dial Tone Detection ON/OFF (DIP Switch 2)
DIP
Switch
1
1
2
2
3
3
Position
ON
OFF
ON
OFF
ON
OFF
Description
Auto-Answer ON *
Auto-Answer OFF
Dial Tone Detection ON *
Dial Tone Detection OFF
Programming Mode
Normal Operation Mode *
* Note:
These are the factory settings.
