20
Installation Procedure
(French Door- Upper Door Adjustment)
There may be ocassions where the upper doors are not aligned to the same height, especially if doors
were removed for maintenance and then reinstalled. With doors in the closed position determine the
alignment required, for example right door is higher than left door.
Alignment procedure:
1. Open doors fully
2. Loosen bottom hinge screws on both doors, see photos below.
Using a 5/32” allen wrench, adjust screw on each door shown below moving the door that is too high
downward and the door that is low upward. You want to adjust both in opposite directions, not just
one door. Note that this moves the lower hinge assembly when adjusted.
Close doors and check alignment, when alignment is
correct, open doors and tighten the lower hinge plate
screws that you loosened at beginning of procedure.