4.0 Features Overview
Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking Electronics, and its affiliates and/or subsidiaries
assume no responsibility for errors and omissions contained in this information. Revisions of this document or new editions of it may be issued to incorporate such changes.
See the Product Manual for complete installation and programming instructions.
Questions? Call Viking Product Support: 715-386-8666
E-1600-30-IP Quick Start Guide
ZF303603 REV B
• Make sure the port is not in trunk mode
• Make sure port is capable of 100mbps full-duplex
• If Spanning Tree Protocol (STP) is enabled, enable Portfast and BDPU
Guard Globally
3.0 Network Port Settings
Rear (PCB) View of E-1600-IP Series
Emergency Phone
Connect to Optional
Strobe Light, LV-1K, etc.
Viking model
SL-2
shown (not included),
see
DOD 242
|
OR
|
MAC:
18E80FXXXXXX
asdesaxtff
N.C. (Gray)
N.O. (Yellow)
COM. (Blue)
Optional 2 Amp Relay
Output Contacts
(2A@30VDC / 250VAC max)
3 Gel-Filled Butt
Connectors
(included)
- Black
+ Red
Black
Black
- Black
+ Red
LED
Help Switch
Info Switch
(optional)
Speaker
Microphone
MAC Address Label:
The MAC
address is a unique 12 digit number
used by routers to send network traffic
to the correct IP address.
PoE LAN Port 10/100, PoE Class 1
(<4 Watts):
Connect to your LAN via
RJ45 plug and CAT5 or greater
twisted pair wire.
Yellow Network Status LED:
Lights
steady to indicate power and data
link. Blinks to indicate network activity.
Green Unit Status LED
Red
Red
Yellow
Yellow
Viking model
LV-1K
shown (not included),
see
DOD 246
Note:
The gel-filled (water-tight) butt connectors are designed for insulation displacement on 19-26 gauge wire with a
maximum insulation of 0.082 inches. Cut off stripped wire ends before terminating.
