C
B
A
4"(10.2 cm
)
4"(10.2 c
m)
6"(15.2 cm
)
SCREW A
BOTTOM
DUCT ASSEMBLY
MAKE FLANGES
FLUSH
Illustration 1
Illustration 2
Illustration 3
NOTE:
SIDE FLANGES ON
DMTK301
ONLY
.
ELECTRICAL OUTLET LOCATION
Outlet should
NOT
be in the shaded area as indicated
on Illustration 1.
NOTE 1:
If the Depth (C) dimension is greater than 1"
(53.3 cm), the outlet location may be in any area on the
rear wall.
NOTE 2:
The floor of the opening should be constructed
of plywood strong enough to support the weight of the
oven and floor load (approximately 100 pounds). The
floor should be level for proper operation of the oven.
Be sure to check the local building code as it may require
that the opening be enclosed with side, ceiling and rear
partition. The proper functioning of the oven does not
require the enclosure.
MOUNTING TEMPLATE
1. Align the mounting template center line with the center
of the cutout and the floor line with the floor of the
cutout. Tape it into place.
. For
DMTK271
, only predrill 4 holes marked “A” with
a 1/16" drill bit. For
DMTK301
, only predrill 4 holes
marked “B” with a 1/16" drill bit.
3. Remove template from the cabinet
BOTTOM DUCT ASSEMBLY
1. Place the Bottom duct in the opening. When the Bottom
Duct Assembly is in the opening correctly, the flanges
will be tightly against the lower edge of the opening.
See Illustration .
. Secure the Bottom Duct Assembly with the two (1-
3
/
16
")
screws A. See Illustration .
CABINET OR WALL CUTOUT
Cutout Dimensions
Height (A)
Minimum
16
3
/
4
"
(4.5 cm)
Maximum
17"
(43. cm)
Width (B)
Minimum
4
3
/
8
"
(61.9 cm)
Maximum
4
11
/
16
" (6.7 cm)
Depth (C)
Minimum
0"
(50.8 cm)
