Viking Designer DMOS200 Скачать руководство пользователя страница 1

VIKING RANGE CORPORATION

111 Front Street

Greenwood, Mississippi 38930 USA

(662) 455-1200

PARTS INCLUDED IN THE KIT 

       

 

5) Template: QTY 1

Minimum Cutout Opening Width 24 3/8" (619.13 mm)

Maximum Cutout Opening Width 24 11/16" (627.06 mm)

14 5/16" (363.475 mm)

M

inimum C

ut

out Op

ening H

eigh

t 16 3/4" (425.5 mm)

M

aximum C

ut

out Op

ening H

eigh

t 17" (431.8 mm)

12 13/16" (325.4 mm)

Distance between holes 

 25 5/8" (650.75 mm)

Distance between holes 

 

 28 5/8" (727.3 mm)

15 29/32" (403.66 mm)

29/32" (23.4 mm)

Center Line

Floor Line of Cutout Opening

BUILT-IN TRIM KIT TEMPLATE

FOR DESIGNER SERIES MICROWAVE OVEN

1.  Align the mounting template center line with the center of 

the cutout and the floor line with the floor of the cutout. 
Tape it into place.

2.  For DMTK271, predrill 4 holes marked 

 with a 

HP

" drill bit.

 

For DMTK301, predrill 4 holes marked 

 

 with a 

HP

" drill bit.

3.  Remove template from the cabinet

TINSKB110MRR0

1) Frame Assembly

Front Frame 

QTY 1

Back Frame 

QTY 1

2) Bottom Duct Assembly: QTY 1

3) Screw A (1-3/16" length): QTY 2

4) Screw B (1 3/4" length): QTY 4

NOTE:

SIDE FLANGES ON 
DMTK301 

ONLY

.

INSTALLATION

INSTRUCTIONS

DESIGNER SERIES
MICROWAVE BUILT-IN TRIM KIT

Retain for Future Reference

IMPORTANT - PLEASE READ AND FOLLOW

•  Before beginning, please read these instructions completely and carefully.
•  Be sure to DISCONNECT THE PLUG of the microwave oven from the electrical outlet before installing the built-in trim kit.  

Remove the turntable from the oven cavity.

•  Because the kit includes metal parts, caution should be used in handling and installation to avoid the possibility of injury.
•  Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty.
•  Please observe all local and national codes and ordinances.  

•  The installer should leave these instructions with the consumer who should retain for local inspector’s use and for future 

reference.

THIS BUILT-IN TRIM KIT IS DESIGNED FOR USE ONLY WITH VIKING MICROWAVE OVENS  SPECIFYING BUILT-IN 

TRIM KIT DMTK271 OR DMTK301 ON THE RATING LABEL ON THE LEFT SIDE WALL OF THE OVEN CAVITY. 
IF YOUR LOWER CONVENTIONAL OVEN IS NOT LISTED IN THE USE AND CARE MANUAL OF THE MICROWAVE 

OVEN, THEN DO NOT INSTALL THE MICROWAVE OVEN ABOVE IT OR IN ANY AREA WHERE HEAT AND STEAM 

ARE GENERATED; FOR EXAMPLE, NEXT TO OR ABOVE A CONVENTIONAL RANGE.

Отзывы: