14
INSTALLATION OF HOLD DOWN BRACKET - DECU MODELS
Two (2) hold brackets will be provided with your unit.
After cooktop has been installed into the countertop, locate
the bracket in the slots as needed (Figure 1). Place a
bracket in the slots and lower until the bracket catches.
(Figure 2). Use the bolt to tighten the cooktop to the
countertop. (Figure 3)
Slots
Mounting
bracket
Push into slots
and down
Figure 1
Figure 2
Figure 3
bolt
Cooktop
Countertop
Top of cooktop
1 1/2” (3.8 cm)
Max. thickness
NOTE:
If countertop is less than 1 1/2” (3.8 cm)
thick, a filler block will have to be used for bolt to
push against. (See figure 4)
Filler block
*There must be a 1” (2.5 cm) clearance under counter on the left and
right side of the cooktop for pull down brackets to be attached.
Do not install brackets on front and rear of cooktop
1” (2.5 cm)
Min. *
