C. Turning the Alert Tones On/Off for Specific Days of the Week
D. Setting Timed Alert Tones
E. Reviewing and/or Cancelling Timed Alert Tones
4
Note:
If more than 128 events have been entered, a long beep will be heard indicating that the
event memory is full.
Step 1.
Press the
MODE
button repeatedly until the
SET DAY
indicator lights. The current day
of the week and “
on
” or “
of
” will be displayed. “
on
” = alert tones are ON and “
of
” = alert
tones are OFF for that day of the week.
Step 2.
Pressing the
SINGLE
button will toggle between flashing the day of the week and
flashing “
on
” or “
of
”. The flashing portion of the display is the section that can be
changed.
Step 3.
With the day of the week flashing, use the
TIME
(
+
and
-/CANCEL
) buttons to select
the day of the week you would like to set to ON or OFF. When the correct day of the
week is displayed, press the
SINGLE
button to flash “
on
” or “
of
”. The day can then be
set to ON or OFF by using the
TIME
(
+
and
-/CANCEL
) buttons.
Step 4.
Review your day of the week programming by pressing the
SINGLE
button until the
weekday (1-7) is flashing, then increment through each day of the week with the
TIME
(
+
) button and monitor each day for its on or off setting. Exit the
SET DAY
mode by
simply pressing the
MODE
button.
Step 1.
Press the
MODE
button repeatedly until the
SET EVENTS
indicator lights.
Step 2.
Increase or decrease the event time by pressing the
TIME
(
+
or
-/CANCEL
) button until
the desired time is shown.
Step 3.
Move DIP switch 2 to
OFF
for bong alert tones or
ON
for buzzer alert tones (see
Programming
section
J
).
Step 4.
Press one of the single, double, or triple
ALERT TONES
buttons to program the number
of alert tones you wish to output at the specific event time. A single, double, or triple
confirmation beep should be heard.
Step 5.
Repeat steps 2-4 for the remainder of your scheduled events.
Step 1.
Press the
MODE
button repeatedly until the
REVIEW/CANCEL
indicator lights.
Step 2.
Press one of the
ALERT TONES
buttons (single, double, or triple) repeatedly to rotate
through the event times associated with that alert tone button. A red LED at the bottom
right corner of the time display will light to indicate a buzzer event time (versus a bong
event).
Note:
Event times are stored in the order of programming, not chronologically.
Step 3.
Press the
-/CANCEL
button to permanently cancel an event tone. A single
acknowledgement tone will be heard. The next consecutive event for that specific alert
tone will then be displayed.
Step 4.
Repeat steps 2-3 as needed to remove the events to be cancelled.
Step 5.
When all events for a given alert tone have been cancelled, the display shows three
dashes (- - -).