12
Installation
Any finished flooring should be protected
with appropriate material to avoid damage
from moving the unit.
If unit has been laid on its back or sides,
place unit upright and allow minimum of 24
hours before connecting power.Re-installl
the doors by removing the upper pivot pin
completely, sliding the door onto the lower
pivot pin and re-installing the upper pivot
pin and fastening tightly. Before moving the
unit, make sure the door is secured to the
cabinet (tape may be required to hold the
doors closed).
1. Plug the unit into the 15 amp grounded
outlet located in the installation opening.
With power applied to the unit, check that
the lighting and cooling function operate
properly, then turn off power to the wall
outlet at the circuit breaker.
CAUTION
4. Slide the cabinet into position, making
sure the rear cabinet leveling legs slide
under the anti-tip devices. Push the
cabinet into the opening until the bottom
front edge of the cabinet is flush with the
surrounding cabinetry or the leveling legs
are tight with the anti-tip devices.
IMPORTANT: The rear cabinet leveling legs
must be engaged under the anti-tip
brackets.
5. Shim the front of the unit so the front face
is flush with surrounding cabinetry. Adjust
the front legs to support the countertop
at the shimmed height. Using an
adjustable wrench or pliers, turn legs
counterclockwise to raise the unit or
clockwise to lower the unit. Countertop
should be resting on top of the unit.
IMPORTANT: If countertop is not resting
entirely on unit top, shim the countertop to
prevent damage to the countertop.
To prevent damage to the countertop and
unit underneath, do not place heavy
objects on countertop directly above the
unit.
CAUTION
Shut off power to the wall outlet before
installing into the opening.
WARNING
2. Check that the following are level and
square:
•
Front face and interior opening
•
Installation opening and floor surface
•
Countertop bottom front edge
IMPORTANT: Leveling legs should not be
extended more than 3/ 4” from bottom of
the cabinet.
IMPORTANT: The floor under the unit must
be at the same level as the surrounding
finished floor.
3. If all surfaces are level:
a. Measure from the floor to the bottom
of the front edge of the countertop
b. Measure the rear of the unit cabinet
from the floor to top of cabinet, at
back corners
c. Adjust rear legs so B measurement
equals A measurement. Using an
adjustable wrench or pliers, turn legs
counterclockwise to raise the unit or
clockwise to lower the unit
6. Check interior door openings inside the
cabinet to ensure the cabinet is level. Re-
install all shelving and drawers. Take
extreme care to insert sliding shelving
and sliding drawers squarely into slide
brackets and proper slide bracket
grooves. When sliding shelving and
drawers are installed properly a click
should be heard from both slide bracket
retaining clips and should slide smoothly
in the tracks. When sliding shelving or
drawers are pulled out to full extension, a
stop is activated to prevent additional
pull-out.
Improper shelving or drawer installation
may not actuate slide stop mechanism.
CAUTION
