15
DO NOT
use the handle or oven door
to lift the oven. Remove door before
installation to ensure that it is not used
to lift the unit.
DO NOT
lift or carry the
door by the handle.
Removing the door must be done by
your dealer, a qualified licensed
plumber, or certified gas installer.
Door Removal
Open door completely.
Fold latches backward until locked in place
Slowly close until latches stop door.
Lift door up and out.
14
READ AND FOLLOW ALL WARNING
AND CAUTION INFORMATION
WHEN INSTALLING THIS APPLIANCE.
• All openings in the wall behind the
appliance and in the floor under the
appliance must be sealed.
•
DO NOT
obstruct the flow of combustion
and ventilation air.
Moving, Handling, and Unpacking
Remove and discard all packing materials,
including cardboard and tape on the outside
and inside of the range.
Remove the burner grates, burner heads, and
bases from the cardboard top packaging.
DO NOT
discard the
metal brackets
supplied with the
range. These are the
anti-tip devices and
must be installed with
the unit.
Refer to “Anti-
tip Device Installation”
section.
Some stainless steel parts may have a plastic
protective wrap which must be peeled off.
The interior should be washed thoroughly
with hot, soapy water to remove film
residues and any dust or debris before being
used, then rinsed and wiped dry. Solutions
stronger than soap and water are rarely
needed.
Avoid any damage to oven vents. The
vents need to be unobstructed and open to
provide proper airflow for optimal oven
performance.
The cooling fan should be operating when
the unit is in operation. If you notice the
cooling fan is not operating or you observe
unusual or excessive noise coming from
the cooling fan, contact a Viking Authorized
Service Center before continuing operation.
Failure to do so can result in damage to
the oven or surrounding cabinets.
Installation
General Information
