EN
NO
37
SV
FI
DA
PL
0478 192 9804 B - EN
14.7 Checking the installation position
of the mowing deck
Maintenance interval:
Every 50 operating hours or as required
(e.g. following severe impacts to the
mowing deck or a poor cut).
The mowing deck is in the correct
installation position when it is tilted slightly
forwards – the front of the mowing deck is
slightly lower than the rear.
●
Park the machine on level ground.
●
●
●
Remove the ignition key and keep it in a
safe place.
●
Select the lowest cutting level. (
Difference in height
A
= 10 mm
14.8 Fuel cock
The flow of fuel in the fuel line is enabled
or interrupted by opening or closing the
fuel cock.
The fuel cock is located on the left under
the fuel tank.
●
Stop the engine. (
●
Engage the parking brake. (
The fuel cock (1) is opened and closed by
turning the control valve (2).
14.9 Tyre pressure
Remove the cap from valve (1).
●
Inflate the tyres to the following tyre
pressures using a suitable air pump
with pressure gauge.
Front tyres:
0,8 - 1,0 bar
Rear tyres:
0,6 - 0,8 bar
14.10 Changing the wheels
In the case of damage (holes, cracks, cuts,
etc.) to the wheels, remove the damaged
wheel and take it to a specialised dealer.
Uniform tyre pressure is a
prerequisite for checking the
correct installation position.
Therefore check the tyre pressure
of all the tyres and adjust if
necessary before checking the
installation position. (
Correct tyre pressure is an
important prerequisite for alignment
of the mowing deck and
consequently for achieving a clean
cutting pattern.
Moreover, the turf may be damaged
by the tyre studs in the case of
excessively high tyre pressure.
Содержание MT 4097 S
