1
FIG.1
1
3
HINGE OUTLINE
5
MODEL VG06071
PREPARATION STEPS TO FOLLOW BEFORE INSTALLATION
1.
Remove the plastic layer from the base/tub border (if needed). Do NOT remove the plastic layer
off the plastic platform of the base/tub.
2.
Properly apply silicone to the wall and base joints.
IMPORTANT
To prevent damage to the finish, you should protect the tub bottom with a cardboard protector
before beginning the installation.
Ensure that there is sufficient structural support behind the shower wall to hold the weight of the
shower door. If there is insufficient support, then reinforce the shower walls with wooden studs
prior to shower door installation. [SEE FIG.1B] (typical for right and left door installation)
INSTALLATION STEPS
A. INSTALLING THE WATER SIDE SEAL STRIP
1.
Clean all glass panel edges receiving seal strips with rubbing alcohol. [SEE FIG.1]
2.
Cut seal strip (#3) according to seal strip diagram. [SEE FIG.1]
3.
Install the side seal strip according to seal strip diagram, making sure that the flange is on the
inside of the shower. [SEE FIG.1]
CAUTION
!
GASKETS NEED TO BE IN BETWEEN ALL GLASS AND METAL CONTACT. FAILURE TO
DO SO CAN LEAD TO BREAKAGE AND POTENTIAL BODILY HARM.
3
1
3
NOTE: If the seal strips are not flat, use a hair dryer to apply minimal heat and press the seal strip back into
position.
STUD
FIG.1B
MAKE SURE THE FLANGE IS
ON THE INSIDE OF THE SHOWER
