str
41
First use of the device
Before using the device for the first time, it is recommended to test the attachment on
the inside of the forearm.
1. Attach the selected attachment to the top of the device as intended. With silicone
sealing rings, a little force is needed and carefully mount with one-sided circular
motion.
2. Turn the device by button push.
3. Press the button again to select the desired intensity from three levels. The fourth
level is the activation of the blue light in conjunction with the skin calming attachment
and the fifth level is the activation of the red light for rejuvenating effect
and softer skin.
4. Before moving on to the face, move one stroke over the inside of the forearm and then
wait about half an hour. If the eventual skin‘s reaction to this time subsides, you can go
to your face.
Use - Tips:
Exfoliation of the dead skin on the face
1. Attach the microcrystalline attachment to the device. Wash and dry face.
2. Start from the lower jaw and move the device from the bottom up.
3. Place the device on your face and move it from the inside out.
4. Place the device on your forehead and move it from the center to the sides.
5. Place the unit on a T-shaped part of the face and move it from bottom to top.
Cleaning pores, grease, cosmetic residues, etc.
1. Attach a large round hole adapter or silicone ring adapter (depending on your skin type).
2. Point the nozzle to the skin parts you want to care for. Do not move the nozzle back
and forth, but only in one direction. Do not use this mode for too long.
Care for fine lines
1. Attach the oval attachment to the device.
2. Use a device to treat the nose and lips. Adjust the suction force according to your needs.
Take care of the part and pull it away quickly. Repeat the procedure several times for
a maximum of 5 minutes.
Skin care with red and blue light
You can start this care right after cleaning. Attach the blue and red light attachment and
move it very slowly. Do not use it in one place for too long to avoid skin redness and dis
-
comfort. Let the red and blue light act on the skin at a distance of 3 cm for 3 to 5 minutes.
Another option is to go straight on the skin, where a gentle massage occurs.
