Specification
Applied Models
Installation
Pick-Up Device
Pick-Up Device
Active Pixel
Active Pixel
TV Resolution
TV Resolution
Video Out
Video Out
Mirror Function
Mirror Function
Operation Temp.
Operation Temp.
Min. Illumination
Min. Illumination
Power Supply
Power Supply
Field of View (D / H / V)
Field of View (D / H / V)
Micron 1/4" SOC VGA
310K (640 (H) x 480 (V))
330 TV Lines At Center
Composite Signal 1.0 p-p, 75
Included
-40 ~ 85 degree C
0.1 Lux (F=2.5)
DC 6.5V~40V (50mA at DC12V)
160.5 / 121 / 88 (degree)
NTSC
PAL
Parts supplied:
A. Rear View Camera .......................................................... 1 pc
B. Extension Cable ( 7.5 m) ................................................. 1 pc
C. Locking Nut for Installation ......................................... 1 pc
D. Reference Manual
1. Clean the surface on the mark where Camera is installed.
2. Check out whether other electronic harnesses are touched inside of
installation mark.
3. Peel off a sheet of protection tape on the lens of camera.
4. Drilling a hole (diameter 6.5 or 7 mm) at the mark
5. Lock up the rear of camera with the installation screw.
6. Adjust the view angle and connect to extension cable.
7. Wire the extension cable to the monitor and navigation.
Diagram of Locking Up Inside of the Installation
Before finally installing the unit, please connect the wiring
temporarily, making sure it is all connected up properly,
and the unit and the system work properly.
Navigation or Monitor
Power Supply
When No connect to the
Reverse light harness,
please connect this side.
- Rear View Camera
Power Supply
- Connect to Reverse
Light Harness
- Rear View Camera
Ground
- Connect to Vehicle
Body
Wiring System Diagram
1
2
3
Yellow
Black
Red
Video
GND
Power
Camera
REVERSE LIGHT HARNESS CONNECTING
+ GROUND
RCA: YELLOW
POWER + GROUND
NRC-2100
NRC-5000
NRC-7000
NRC-7100
Garnish Type
(Unit: mm)
Locking Nut
