English
Troubleshooting
No sound from any speakers
• Power is not turned on
- Verify the power adoptor is plugged into the wall outlet.
• Volume setting is too low
- Verify the Power On switch has been pressed.
- Press the function key to raise the system Master Volume.
- Check volume level on computer sound card or alternate audio source device and set
at
mid
level.
• Audio cable is not connected to audio source
- Connect audio cable from audio source. Make sure thee signal cables are inserted
firmly
into
the correct jacks.
• Audio cable connected to wrong output on audio source
- Make sure that the lime green 3.5 mm stereo jack is connected to the line-out of the
audio
source; make sure it is fully inserted.
Sound is distorted
• Volume level set too high
- Decrease the speaker system's master volume level.
• Windows volume control is set too high
- Adjust the Windows volume and balance controls to the center as a starting point, then
use
the speaker controller to adjust the volume.
• Sound source us distorted
- WAV files are often of poor quality. So distortion and noise are easily noticed with high-
powered speakers. Try a different sound source like a music CD.
Driver
Tweeter: 1” (2.54cm)
Micro Driver Full Range: 2” (5.08cm)
P.M.P.O.
600Watt.
RMS
20Watt
Frequency Range
35
Hz ~ 20 KHz
Amplifier
Internal
Function
Power / Volume
Indicator
Power
Power Supplier
External
Adaptor
AC input Power: 100 ~ 240V
DC output Power: 12V / 1.66A
Connector
Stereo jack / RCA
Dimension
267.7mm (H) x 90mm (W) x 105.3 (D) mm
10.54” (H) x 3.54” (W) x 4.15” (D)
Contents
Connection cables X 2
Adaptor X 1
User Guide X 1
Speaker X 2
Stereo Jack-RCA adaptor x 1 (optional)
THD
<0.4
%@-7dB
Regulations
CCC, BSMI, CE, C-tick, VCCI, ICES003, UL,
FCC-B, CB, NOM, GOST, PCBC, PSB
Specifications
ViewSonic SP2002 3
