22
LAN port and RS-232C port are disabled when Network Settigs to the HDBaseT and RS232
settings to HDBaseT channel.
Use LAN cables of up to 100m long. Exceeding this length, the image will be deteriorated,
and can experience malfunction on LAN transmission.
HDBaseT BEST PRACTICE:
i. When In Doubt, Use Shielded Cat6 With Shielded Plugs.
ii. Use Proper Grounding.
iii. Isolate HDBaseT Cat Cables from Other Signal Types.
HDBaseT control function table
O : Enable X : Disable
Connecting a Component Video source device
Examine your Video source device to determine if it has a set of unused Component Video
output sockets available:
•
If so, you can continue with this procedure.
•
If not, you will need to reassess which method you can use to connect to the device.
1.
Take a VGA (D-Sub)-Component adaptor cable and connect the end with 3 RCA type
connectors to the Component Video output sockets of the Video source device. Match
the color of the plugs to the color of the sockets; green to green, blue to blue, and red
to red.
2.
Connect the other end of the VGA (D-Sub)-Component adaptor cable (with a D-Sub
type connector) to the
COMPUTER IN
socket on the projector.
If the selected video image is not displayed after the projector is turned on and the correct
video source has been selected, check that the Video source device is turned on and
operating correctly. Also check that the signal cables have been connected correctly.
Control
Side
Function
Projector Mode
Remark
Green
Mode
Network
Standby
Normal
Projector
Front-IR(wireless)
O
O
O (Can disable
by OSD)
Top-IR(wireless)
O
O
O (Can disable
by OSD)
RS-232
O
O
O (Can disable
by OSD)
LAN
X
O
O (Can disable
by OSD)
HDBaseT
TX Box
HDBT-IR(wireless)
X
X
O
RS-232
X
X
O
LAN
X
X
O
Содержание LS900WU
Страница 98: ......
