Viessmann Vitodens 200-W System, Инструкция по эксплуатации для пользователя системы

Страница: 12 / 72

12
As the user of new combustion equipment, you may be
obliged to notify your local flue gas inspector of the
installation [check local regulations]. Your local flue gas
inspector will also inform you [where appropriate]
about work that may have to be carried out on your
combustion equipment (such as regular checks, clean-
ing).
Your system is preset
Your heating system is preset at the factory and is
therefore ready for operation following commissioning
by your contractor:
Central heating in weather-compensated operation
■ Between 06:00 and 22:00 , rooms are heated to
20 °C ( "Standard" temperature level).
■ Between 22:00 and 06:00 , rooms are heated to 3 °C
( "Reduced" temperature level, frost protection).
Central heating in constant operation
■ Between 06:00 and 22:00 , the set flow temperature
is 60 °C ( "Standard" temperature level)
■ Between 22:00 and 06:00 the set flow temperature
is 20 °C ( "Reduced" temperature level, frost protec-
tion)
Central heating in room temperature-dependent
operation
■ The rooms are heated in accordance with the set-
tings on your room temperature controller.
DHW heating
■ Between 05:30 and 22:00 , the DHW is heated to
50 °C ( "Standard" temperature level). Any installed
DHW circulation pump is switched on.
■ Between 22:00 and 05:30 , the DHW cylinder is not
reheated. Any installed DHW circulation pump is
switched off.
Note
Any DHW heating started before 22:00 remains on
until the set DHW temperature has been reached.
Frost protection
■ Your heat generator and DHW cylinder (if installed)
are protected against frost.
Wintertime/summertime changeover
■ This changeover is automatic.
Date and time
■ The date and time were set by your heating contrac-
tor.
You can change the settings at any time to suit your
individual requirements.
Power failure
All settings are retained if there is a power failure.
Introductory information
Commissioning
(cont.)
6172108