Viessmann Vitodens 100-W B1HA, Инструкция по применению

Страница: 24 / 48

20
B1HA Boiler Setup
Application Code
VD1X 1HC1T1ZP.01
This particular application represents a low mass boiler with a single system
loop. Because the system flow requirements may vary, or fall outside of the
parameters of the boiler flow, it is recommended to hydraulically separate the
system flow from the boiler flow. This can be achieved by using a low loss
header or closely spaced tees on the system loop. Upon a call for heat from
an external demand such as a thermostat the boiler circulator and the system
circulator will be initiated. To program the boiler for this type of application,
please complete the following procedure:
1
1
2
2
3
3
4
4
OR
Adjust the Boiler
Setpoint Temperature:
(No Outdoor Sensor
Connected)
Set and Outdoor
Reset Curve:
(With Outdoor
Sensor Connected)
Tap the / button until the
begins flashing.
Press
OK
.
Press the / until the required boiler
water temperature is displayed.
Press
OK
to confirm.
Tap the / button until the
begins flashing.
Press
OK
.
Using the chart below, select the
number of the desired reset curve for
your application.
(value shown on the boiler display will depend
on whether the boiler is set to °F or °C)
Press the / until the required curve
is selected and press
OK
.
Step # Function Description
G0!40
&1044&/!40
*For more informaiton on how to reconfigure the boiler, please reference page 40.