Viessmann AQUAHOME 20-N, Инструкция по установке и эксплуатации

Страница: 19 / 41

With factory settings (97 and OFF)
this function is not active. When
activated by pressing the
▲
or
▼
buttons (the display screen will show
alternately flashing 97 and OFF
captions) the device will activate
regeneration process each time when
the ion exchange capacity of the resin
has been used in 97%, regardless of
the time of day.
Setting of this function can only be
implemented by the service team of
the supplier or manufacturer.
Press again (but do not hold) the
“SET” button, until the display screen
shows 12-hour or 24-hour clock
mode.
Setting clock mode (12-hour clock
or 24-hour clock)
Press the
▲
or
▼ button until the
display screen shows the desired
value, in order to 24-hour clock mode
to 12-hour clock mode and vice versa.
Backwash and fast rinse duration
time
Press again (but do not hold) the SET
button until the display screen shows
DURATION TIME caption.
press again (but do not hold) the SET
button until the display screen shows
the duration time of backwash
SET
TIME bA and a number such as 5,
that will begin to flash. This means
that the backwash duration time is set
to 5 minutes. If the “SET” button is
pressed again the display screen will
show
SET TIME Fr and a number,
such as 2 that will begin to flash, to
set the fast rinse duration time. This
means that the fast rinse duration
time is set to 2 minutes.
The change of duration time of the
regeneration cycles referred to
above can only be implemented by
the service team of the supplier or
manufacturer.
Then press again (but do not hold) the
SET button until the display screen
reads SET as well as Ctrl.
Additional output of the control
panel
Additional signal output to control
peripherals. Press the
▲
or
▼ until
the display screen shows OFF
caption.
Press again (but do not hold) the
“SET” button, until the display screen
shows current time (hour).
Setting of the functions referred to
above can only be implemented by
the service team of the supplier or
manufacturer.
C. Additional functions featured by Aquahome 30-N

SALT EFFICIENCY (Lower
salt consumption mode),

CLEAN FEATURE (cleaning
function),

CLEAN FEATURE MINUTES
(Duration of cleaning),

MAXIMUM DAYS BETWEEN
REGENERATIONS
(Maximum time period between
regenerations in days
during water uptake idle
period),

97% FEATURE (Automatic
activation of the regeneration
process after the ion exchange
capacity of the resin has been
used in 97%),

12/24 HOUR CLOCK (12-hour
or 24-hour time display
mode),

BACKWASH & FAST RINSE
TIMES (Duration of
backwash and
fast rinse),

Salt tank illumination

Water flow through
the device

Time remaining for completion
of regeneration and indicators
of valve position
To set any of the functions listed
above, press the
“SET” button and
hold it, until the display screen shows
“000”.
Then press again the
“SET” button,
but do not hold it
– the display screen
will show the SALT EFFICIENCY
mode (the display screen will show
letter
E ). In order to activate or
deactivate the above function, press
▲
or
▼ button, until the display
screen shows ON or OFF.
19