Viega MegaPress XL PressBooster 4896.2XL, Инструкция по эксплуатации

Страница: 11 / 16

MegaPress XL PressBooster - Instruction Manual
US
11
3.3 Pressing
CAUTION!
Risk of crushing
Risk of getting your fingers and hands crushed.
– Hold the press tool during pressing with both hands at the handles.
NOTICE!
Property damage due to defective press ring
Using a defectively, incorrectly dimensioned, or worn press ring may result in
incorrect pressing.
– Before using the press rings, check them for visible defects.
– Only use defect-free press rings of a suitable size.
Also observe the instruction for use of the press machine and the MegaPress XL
piping system you are using.
Requirements:
„
The dimension of the press connector matches the dimension of the press ring.
X
7 Open the press ring and place it around the respective pressing point of the press
connector.
X
8 Pull the handle at the hinged adapter jaw back.
Z
The hinged adapter jaw opens.
X 9 Move the open hinged adapter jaw to the press ring (1).
X
9 Insert the ball heads of the hinged adapter jaw into the contact points of the press
ring.
NOTICE! Make sure the ball heads sit correctly in the contact points of the press ring.
X
Push the handle forward (2).
Z
The hinged adapter jaw closes.
X
10 Align the PressBooster so that safe footing is ensured during pressing.
X
10 Depress the trigger on the press tool once to initiate the pressing process, wait two
to three seconds and press the trigger a second time. The pressing process is complete
and the rollers at the front of the booster will retract and the hinged adapter jaw will open.
If the rollers do not slide back and allow the hinged adapter jaw to release, press the
trigger a third time. The third press is a release cycle that brings the rollers back to their
original starting position.
Z
You have pressed the MegaPress XL press connector to the steel pipe.