Vido WD010611400, Инструкция по эксплуатации

Страница: 9 / 16

1400W ANGLE POLISHER ENG
b) Never place your hand near the rotating accessory. Accessory may kickback over your hand.
c) Do not position your body in the area where power tool will move if kickback occurs. Kickback will
propel the tool in direction opposite to the wheel’s movement at the point of snagging.
d) Use special care when working corners, sharp edges, etc. Avoid bouncing and snagging the
accessory. Corners, sharp edges or bouncing have a tendency to snag the rotating accessory and
cause loss of control or kickback.
e) Do not attach a saw chain woodcarving blade or toothed saw blade. Such blades create frequent
kickback and loss of control.
3) Safety Warnings Specific for Sanding Operations
Do not use excessively oversized sanding disc paper. Follow manufacturer’s recommendations, when
selecting sanding paper. Larger sanding paper extending beyond the sanding pad presents a
laceration hazard and may cause snagging, tearing of the disc or kickback.
4) Safety Warnings Specific for Polishing Operations
Do not allow any loose portion of polishing bonnet or its attachment string to spin freely. Tuck away or
trim any loose attachment strings. Loose or spinning attachment strings can entangle your fingers or
snag on the workpiece.
5) Safety Warnings Specific for Wire Brushing Operations
a) Be aware that wire bristles are thrown by the brush even during ordinary operation. Do not
overstress the wires by applying excessive load to the brush. The wire bristles can easily penetrate light
clothing and/or skin.
b) If the use of a guard is recommended for wire brushing, do not allow any interference of the wire
wheel or brush with the guard. Wire wheel or brush may expand in diameter due to work load and
centrifugal forces.
6) Additional Safety and Working Instructions
a) Keep handles dry, clean and free from oil and grease. Slippery hands cannot safely control the
power tool.
b) Only use "wrap around" control handle, supplied with tool. Use of an auxiliary side handle will
cause the hand to be within reach of the spinning accessory.
c) Use clamps or other practical way to secure and support the workpiece to a stable platform.
Holding the work by hand or against your body is unstable and may lead to loss of control.
d) Ensure that the tool is tightened before use and run the tool at no-load for 30 seconds in a safe
position. Stop immediately if there is considerable vibration or if other defects are detected. If this
condition occurs, check the machine to determine the cause.
e) Do not leave the tool running. Operate the tool only when hand-held.
ARNING
DOUBLE INSULATION
The power tool is double insulated. This means that all the external metal parts are electrically insulated
from the main power supply. This is done by placing insulation barriers between the electrical and
mechanical components making it unnecessary for the power tool to be earthed.
9