Vidikron Vision 85, Руководство по эксплуатации для владельца

Страница: 42 / 88

Installation
30 Vidikron Vision 8 5 Owner’s Operating Manual
PRE
L
IMINAR
Y
Connecting to AC Power The Vision 8 5 system includes two (2) AC power cords (one each for the projector and VHD
Controller).
Plug the female end of one power cord into the AC receptacle on the rear of the Vision 8 5 (AC
100V to 240V). Then, connect the other end to your AC power source. Similarly connect the
VHD Controller to a nearby AC outlet.
3.6
Turning on the Power 1. Turn on your source components.
2. Turn on the main power switch at the rear of the VHD Controller.
3. Press the ON button on the remote control – or the POWER ( ) button on the VHD
Controller front panel – to turn on the system. The vacuum fluorescent display on the
VHD Controller front panel briefly displays “Starting Display.”
4. When the projector is ready for use, the fluorescent display indicates the active source,
signal format (NTSC or PAL), input resolution and aspect ratio; for example:
3.7
Adjusting the Picture
Orientation By default, the Vision 8 5 is configured for a “floor/front” installation, in which the projector is
installed upright and in front of the screen. If it is installed behind the screen and/or mounted
on a ceiling, you must change the picture orientation. To do this:
1. Select an input OTHER THAN HDMI 1 or HDMI 2 on the VHD Controller.
2. Press MENU and enter the Service Menu passcode.
3. Select Service from the Main Menu.
4. Select Display Device from the Service Menu, then select Configure.
5. Press , then choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match the installation
method.
➤
Component SD NTSC 480i
16:9 V85
Current Source Format
Input
Resolution
Aspect Ratio
You must enter a passcode to access the Service menu.
Note