Vidikron PLASMAVIEW VP-103VHD, Руководство по установке и эксплуатации

Страница: 59 / 82

Operation
Vidikron PlasmaView VHD Installation/Operation Manual 47
PRE
L
IMINAR
Y
• You have multiple VHD Controllers and want to control them independently, as opposed
to broadcasting commands from a single remote to all of them. In this scenario, you can
use multiple remotes programmed to use different IR codes. Or, you can use a single
remote and change the IR code as needed to address a specific device.
When you change a remote code on the VHD Controller, you must re-program your remote
control to send that same code. To do this:
1. Using a straightened paper clip or similar object, press and hold the
CODE button on the remote control for approximately three
seconds, or until the LED on the remote lights solid red.
– OR –
If your remote control unit does not have a CODE button, press and
hold the LIGHT button on the remote control for approximately
three seconds, or until the LED on the remote lights solid red.
2. Enter a new two-digit code between 00 and 31 inclusive. Use the
16:9 button for “9” and the 4:3 button for “0.” Include a leading
zero for single-digit codes; for example, enter 9 as “09.”
3. The LED turns off to confirm the code change. If you enter an invalid code, the LED
flashes for three or four seconds. Try again, entering a valid code.
Display Device: The options in the Display Device menu allow you to perform certain
adjustments at the plasma display.
• Display Position: Select Display Position from the Display Device menu to perform the
following display device adjustments (these are global, independent of any input):
• Select Left/Right or Up/Down and use the or buttons to fine-tune the displayed
image position.
• Select Width or Height and use the or buttons to fine-tune the display device
aspect ratio.
• Select Pix By Pix from the Display Position menu and set it to Enable to have the
PlasmaView VHD map a 1920x1080 input signal to 1080p HD panel pixels, displaying
100% of the original content. By skipping the scaling process, the PlasmaView VHD can
produce high-definition images in their original, 1:1 pixel form.
When Pix By Pix mode is disabled, the picture source is scaled for over-scanning and
97% of the original is displayed. Use this setting to minimize or elimate image flicker.
Use the VHD Controller front-panel keypad to change its IR code. Then,
change the code sent by the remote to match as described below.
Do not change the “Type” setting in this menu.
1. Pix By Pix is available only when the input signal is 1080i or 1080p.
2. You cannot adjust the Width or Height when Pix By Pix is enabled.
Tip
Note
NT
CODE
Note