USER INSTRUCTION
Adjusting the number of rings, privacy time and intercommunication:
Number of rings: -
To program the number of rings the monitor must be in programming mode. This is achieved by
pressing the two following buttons at the same time – the left button of the
volume control and the right button of
the
colour intensity control. When the programming mode is entered LED1 starts flashing, this will automatically
reset after 20 seconds of idle time. When in the programming mode press and hold the
button, LED1 will stop
flashing and LED2 will start to flash showing the number of rings (each flash = 1 ring, i.e. 6 flashes = 6 rings) once the
required value of rings has been reached, release the
button. LED1 will start flashing again to signal that other
programming operations can be performed. After a short period with no further buttons being pressed, programming
mode will end.
Privacy Operation: -
Press and hold the
button and the
button (for approx. 3 seconds) to enable the
privacy function. LED3 next to the button illuminates and the unit emits a beep. To set the privacy duration press
and hold the
button, LED 1 will stop flashing and LED 3 will start to flash showing the number of times the
button is pressed (each flash = 15 minutes i.e. 8 flashes = 2 hours). Once the duration has been reached release
the
button. Wait approx 10 seconds for LED1 to stop flashing to signal that the new value is stored.
Intercommunication: -
Firstly please note that extension 1 is mandatory. One extension in each apartment must
be set as extension 1. To intercommunicate with another device in the same apartment simply press the
button the number of times of the extension to call i.e. to call extension 3 press the button 3 times and wait. To
intercommunicate with another apartment (dip-switch 1 on SW3 only) simply press the
button the number
of times of the phone ID to call and wait for an answer.
To open the door press the
button. To end the call press the
button.
An incoming call will be signalled by
an audible tone from the videophone
and the picture will appear (the
picture will only appear on extension
phone 1).
UISL5488 1.0
Press the
button once and speak
with the caller, alternatively hold the
button for 3 seconds to activate
simplex speech. Then pressing and
holding the button will allow speech
to the door and releasing it will allow
speech from the door.
STEP 1
STEP 2
STEP 3
ANSWERING A CALL
Art.SL5488 Telephone
