General information
7
TFT−1500 / TFT−2000
Order−No. M570218AC/012004
© 2004 videotronic infosystems gmbh
ALL RIGHTS RESERVED
1.4
Safety precautions
Caution:
Read these operating instructions carefully before starting up any of
the components. This will avoid any damage or malfunction resulting from
incorrect use.
1. Only operate the device with the stated operating voltage.
2. Never use the device for any purposes other than those designated.
3. Repairs may only be carried out by authorized personnel.
4. Use the device only in dry, dust−free, non−hazardous locations.
5. The device shall not be exposed to dripping or splashing and no objects
filled with liquids, such as vases, shall be placed on the device.
6. Do not touch the screen directly with fingers.
The oils from your skin may leave marks an the surface of the screen, which
are difficult to be removed and may damage the screen permanently.
7. Do not apply pressure to the LCD screen because the LCD is very delicate
and fragile component.
8. Do not allow any cables from the monitor to lie an the floor in an area where
pedestrians are likely to trip causing injury and do not put any heavy
subjects on the power− or signal cable.
9. Only use attachments/accessories specified by the manufacturer.
10.Use only with the cart, stand, tripod, bracket, or table specified by the
manufacturer, or sold with the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to avoid injury from tip−over.
11. Please follow the instructions on maintenance and care of the device which
are contained in these operating instructions (see chapter 3.8).
Caution: Dangerous Voltage!
Disconnect the device from the power supply
immediately if any liquid or solid matter enters the housing. Have the device
checked by your authorized dealer before using it again.
12.Observe any warning signs that may be attached to the device.
13.Protected the power supply externally.
14.Install the device in such a way that no vents are covered and also make
sure that the vents are not covered by any foreign objects. Do not insert any
metal objects into the ventilation holes of the monitor case.
