Videotec VERSO Hi-PoE IPM, Инструкция по эксплуатации

Страница: 14 / 74

EN - English - I
nstruc
tion manual
12 MNVCHPVHPOE_2024_EN
OPERATING STATUS
LED LED Status Apparatus Status
LD1 (Power
supply)
Off The device is not powered
On The device is correctly powered
LD2 (Ca-
mera)
Off The camera is not connected or
Cold Start is active
On The camera is correctly powered
1 flashing The camera has a low identification
resistance
2 flashings The camera has a high identifica-
tion resistance
5 flashings The camera has an excessive ener-
gy consumption
9 flashings The camera requires more energy
than the available
LD3 (Demi-
sting)
Off Demisting was not correctly
detected
1 flashing Standard demisting is inactive
2 flashings The anti-ice system (optional) is
inactive
On Demisting, or anti-ice system, is in
function
LD4 (Heater) Off Heating is not available or power
available is not sufficient
1 flashing Heating is inactive
On Heating is active
LD5 (Illumi-
nator)
Off The illuminator (optional) is not
detected or the available power is
not sufficient
1 flashing The illuminator is correctly
powered (illuminator activation is
controlled by its photocell)
LD6
(Delayed
activation)
Off Heating is not available
1 flashing The pre-heating procedure is
inactive
On The pre-heating procedure is
underway
Tab. 4
9 Maintenance
9.1 Kit for upgrading of the
equipment
Remove the slide (01), the electronic board (02) and
the heating (03).
02
01
03
Fig. 15
If the housing is provided with a blower with a
double filter for air renewal it is also necessary to
replace the blower with the one included in the kit.
Fig. 16
For kit installation information refer to chapter 6
Installation, page 7.
10 Cleaning
10.1 Cleaning the window and
plastic parts
Avoid ethyl alcohol, solvents, hydrogenated
hydrocarbide, strong acid and alkali. Such
products may irreparably damage the
surface.
We recommend using a soft cloth with neutral soap
diluted with water or specific products to clean the
glasses lenses.