Videotec UEBP4, Инструкция по эксплуатации

Страница: 6 / 44

EN - English - I
nstruc
tion manual
4 MNVKUEBP4_1920_EN
6.3 Fixing the base to the support
Use the screws and washers provided.
Put some thread-locker into the holes for
screws (Loctite 222®).
Pay attention to the fixing. Tightening
torque: 4.5Nm (±0.2Nm).
Fasten the base (01) on the support (02) using the
screws and washers (03).
03
01
02
Fig. 6
6.4 Connection of the connector
board
The ground cable must always be connected to the
relevant terminal (GND).
The remaining 3 or 6 cables can be connected to the
connectors’ board based on installation requirements.
Refer to the PTZ unit manual for connection and
completion of PTZ unit installation.
6.5 Mobile connectors cabling
(Ethernet)
Use of Ethernet cables with the following
characteristics is highly recommended:
• Cable diameter: from 5mm up to 6mm (0.24in).
• For the type of cable, refer to the PTZ unit manual.
Cable the mobile connector by operating as follows.
Insert the Ethernet cable using the sealing nut (01),
the cage (02), the gasket (03) and the body of the
connector (04).
01 03
02 04
Fig. 7
Crimp connector RJ45.
Carry out the connections as described in the table
(according to the standard specifications: TIA/EIA-
568-B) (Tab. 1, page 4).
CONNECTION OF THE ETHERNET CABLE
Pin number Cable color
1 Orange-White
2 Orange
3 Green-White
4 Blue
5 Blue-White
6 Green
7 Brown-White
8 Brown
Tab. 1