EN - English - I
nstruc
tion manual
2
MNVKUEBP_1920_EN
5.1 Unpacking
When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
When returning a faulty product we recommend
using the original packaging for shipping.
Keep the packaging in case you need to send the
product for repairs.
5.2 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
5.3 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Support for railing fastening
• Bolts and screws
• Instruction manual
6 Installation
6.1 Mounting the bracket
Take special care when attaching and
fastening down the apparatus. If it is to be
attached to a concrete surface you must
use dowel pins with a traction torque rating
of at least 300dN each. For a metal surface
use screws with a diameter of at least 8mm
and of an appropriate length. The fastening
system must be capable of supporting
at least 4 times the weight of the entire
equipment (pan & tilt, lens, camera,
supports and adapters).
The cables must be adequately fastened to
the structure to avoid the excessive weight
causes accidental removal.
The support can be combined with a counter-plate
(UEAW) or it can be directly fastened to the chosen
surface.
Fasten the support using the 3 holes (01). Use the
screws with a diameter equal to 8mm.
For correct perforation of the fastening surface,
use the perforation masking in this manual. (Fig. 4
Perforation masking for UEBP0, page 4).
01
Fig.
1
6.2 Fixing the base to the support
Use the screws and washers provided.
Put some thread-locker into the holes for
screws (Loctite 222®).
Pay attention to the fixing. Tightening
torque: 4.5Nm (±0.2Nm).
