Videotec MICRODEC485, Руководство по эксплуатации

Страница: 14 / 37

Page 3 MICRODEC485 9951
Operating data on the rating plate
The MICRODEC485 receiver is supplied with two rating plates in conformity with the EC standards.
The first plate contains:
•
Model identification code (Extended 3/9 bar code)
•
Power supply (Volt)
•
Frequency (Hertz)
•
Power consumption (Watt)
The second label indicates the serial number of the model (Extended 3/9 bar code).
During the installation phase, make sure that the power supply features of the receiver correspond to the
characteristics required. The use of unsuitable devices can lead to serious risks for the safety of the personnel and the
security of the plant.
Description of the MICRODEC485 receiver
MICRODEC485 is a microprocessor controlled receiver for the remote control of 24V~ Pan & Tilt motors and of
motor zoom lenses of polarity inversion.
Features
•
8 Functions: UP, DOWN, LEFT, RIGHT, ZOOM TELE, ZOOM WIDE, FOCUS NEAR, FOCUS FAR.
•
32 identification addresses, selectable by Dip switch
•
Direct installation in HEG, HEB, HEC housings
•
RS485 serial input (1200/9600 Baud)
•
Opto-insulated digital logic and power part
•
2 diagnostic leds
•
Power supply: 24 V~ 50/60Hz
•
Pan & Tilt Power supplied: 24V~ 50/60Hz
•
Lens tension: 12V
Ùý
50mA (polarity inversion)
•
Receiver consumption: 1W
Compatible devices
•
DCS3: control keyboard.
Please refer to each user’s manual for a complete description of the features of the single units.
Installation
The unit must be installed exclusively by skilled technical personnel
.
Before carrying out the following operations, if not otherwise stated, always disconnect the unit from power
supply
.
Unpacking
If the packaging does not present evident faults (due to falls or anomalous scratches), make sure that its contents
correspond to the list of items contained in paragraph
Contents of the packaging,
in section
Introduction.
The installer will take care to dispose it according to the recycling programs or, in any case, according to the rules in
force in the country of destination.