English
EN-41
Symptom
Image not
displaye dcorrectly.
Image blurred.
Part of image
out of focus.
Image is dark.
Colors too light.
Bad shading.
Message Reminders.
“Lamp is
approaching the
end of its useful
life in full power
operation.
Replacement
suggested!”
Image is unstable
or flickering.
Cause
The input signal is not
supported by the projector.
The lens is dirty.
The lens focus is not adjusted
optimally.
The projection distance is not
within the projector’s
supported range.
The projector’s screen
placement angle is tilted too far.
The brightness or contrast has
not been adjusted properly.
The lamp is near the end of its
service life.
The saturation, tint, color R,
color G, color B has not been
adjusted properly.
The screen is dirty.
The lamp is near the end of its
service life.
The lamp is near the end of its
service life.
The tracking has not been
adjusted properly.
The monitor color of your computer
has not been adjusted properly.
Measure
Refresh the input signal rate.
Wipe clean with a soft, dry
cloth or lens paper.
Adjust the focus with the
focus ring.
Place the projector within the
supported range.
Adjust the screen placement
angle.
Adjust the brightness or
contrast in the “Color
(Computer/Video Mode)”
menu properly.
Replace with a new lamp.
Adjust the saturation, tint,
color R, color G or color B in
the "Color (Computer/Video
Mode)" menu properly.
Wipe clean with a soft, dry cloth.
Replace with a new lamp.
Replace with a new lamp.
Adjust tracking in the “Image
(Computer Mode)” menu
properly.
Change the monitor color
setting from your computer.