5
1. W INSTALLATION AND SETUP
INSTALLATION MANUAL
W & WIP
Alarm panel
1.4 SIM Card Installation
Insert a Mini-SIM 2FF SIM card in the location shown in the image.
Please refer to the markings for the insertion direction.
Use a M2M (machine-to-machine) 2G3G SIM card. If the panel is
used with a smartphone application, the SIM card shall be able to
receive SMS.
DO NOT insert or remove the SIM card while the panel is powered.
1.3 Ethernet cable connection
Once the panel is fixed on the wall connect a RJ45 cable between the site internet network and the panel Ethernet port.
When the panel attempts a transmission via Ethernet, a red LED on the connector will flash. This will allow the installer to
check whether the panel is connected to a valid network.
Do not touch the RJ45 cable when the panel is powered.
IMPORTANT :
Only connect the panel on 10Base-T SELV networks.
Only for WIP 720/730 models
1.5 Powering and initialization
AC Power
•
Connect the backup battery.
•
Install the power supply inside or outside the panel box
depending on the needed cable length.
•
Connect the power supply to the panel mini-USB connector.
•
Plug the power supply in an electrical outlet.
•
Do not connect the 12V input (sealed by a label), specifically when
the panel is powered.
Initialization
•
Leave the panel open.
The green status LED is on. Press and hold
the INIT button for 6-7 seconds until the status LED turns red for 1
second.
•
The red LED blinks several times then turns off. That procedure
resets the panel memory.
•
The panel is now reset, a Videofied
®
keypad has to be enrolled to
configure the panel.
Backup battery