11
W and WIP Panel www.videofied.com
2. W panel programming
IP
PARAMETERS ?
OK
or
YES
ETHERNET parameters configuration
DHCP :
ENABLED
PANEL IP
DHCP :
DISABLED
OK
or
YES
IP MASK
GATEWAY
PRIMARY
DNS
SECONDARY
DNS
IP
PARAMETERS ?
ESC
NO
ETH. STATUS ?
TEST IN PROGRESS
OK/YES = END
ESC
NO
OK
or
YES
PANEL IP
XXX.XXX.XXX.XXX
ETH. STATUS ?
ESC
NO
ESC
NO
During this test, the panel tries to connect to the local Ethernet Network. The result of
this test can be:
• If the connection is successful:
the local IP of the panel will be displayed
(you
can display other Ethernet parameters with the arrows
).
• ETHERNET OFF NO STATUS
: the Ethernet module is switched off. Please verify
that the Ethernet cable is connected and try again..
• NETWORK/CABLE MISSING
: the panel doesn’t detect Ethernet Cable or
Network
By setting the DHCP as ENABLED,
a new IP address will be assigned
dynamically to the panel every
time it connects to the network.
Network parameters will not be
asked.
If the router forces a static IP
address for the panel, there will
then be a need to define DHCP
as DISABLED. You will then need
to fill in the following network
parameters fields :
Panel IP, IP Mask, Primary DNS,
Gateway and Secondary DNS
Warning: Verify that the IP
address selected is available on
the Network and accepted by the
router.
ESC
NO
Only for models WIP 210/220/230, WIP 620/630 and WIP 720/730
I N S T A L L A T I O N
M A N U A L
