Regulatory Information
FCC Part 15
This device complies with FCC Rules Part 15. Operation
is subject to the following two conditions:
1.) This device may not cause harmful interference and,
2.) This device must accept any interference that may be received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved
by RSI VIDEO TECHNOLOGIES can void the user’s authority to
operate the equipment
Mounting
>
Use proper tools and hardware.
>
Mount indoors in a temperature-controlled environment.
>
Mount camera 2.1 to 2.3 m (6.9 to 7.5 ft.) from the floor.
>
Mount detector on an outside wall, aimed at area to
be secured.
>
Do not aim detector at windows, especially those that
let in direct sunlight, or at heat sources such as lamps,
fireplaces, radiators, and heating vents.
>
Do not aim detector at moving objects such as curtains,
fans.
Specifications
Panel Compatibility
VIDEOFIED VISIO1000/V6000/V7000
Operating Frequency
868/915/920 MHz
Radio type
Spread Spectrum Bidirectional RF
Power Requirements
Three 3.6 V lithium batteries
Battery Type
LS14500
Motion detection
Lens: Fresnel
Detection distance: 12 m/ 40 ft.
Angle: 90°
Detector type: Dual elements
Weight threshold: 18 kg/40 lbs.
Camera sensor
CMOS black & white
Video resolution
320 x 240 pixels
Video sequence (in alarm)
5 frames/s for 10 seconds
Video sensitivity
0.2 lux
Lens
Wide-angle 85° (no IR treatment)
Night illumination type
Infrared (LED)
Night illumination distance
4.5 m/14 ft.
Operating Temperature
0°/+40°C (32°/104°F)
Maximum Relative Humidity
70%, non-condensing
Dimensions
89 mm x 70 mm x 70 mm
(LxWxD): 3-1/2 in. x 2-3/4 in. x 2-3/4 in.
Weight
150 g/5.3 oz. (without batteries)
Approvals CE / EN50131 / EN300220 / INCERT/ IDA / NCP (DCV200)
UL / FCC (DCV600)
A-Tick (DCV700)
1
Separate base from camera.
2
Hold camera base against
mounting surface and mark the
two appropriate mounting holes.
3
Drill pilot holes and install
anchors where needed.
4
Place base on mounting surface
so mounting holes line up with
pilot holes/anchors and secure
base with appropriate screws.
5
Install batteries into camera, observing correct polarity.
6
Attach camera to base and secure with screw.
EMEA SALES
2, rue Alexis de Tocqueville
92160 ANTONY
FRANCE
Phone +33 (0)1 55 59 10 25
Fax +33 (0)3 90 20 66 36
© 2008 RSI VIDEO TECHNOLOGIES. VIDEOFIED
TM
is a Registered Trademark of RSI VIDEO TECHNOLOGIES.
S
2
View
®
is a registered trademark of RSI VIDEO TECHNOLOGIES. Specifications subject to change without notice.
USA SALES
4455 White Bear Parkway, Suite 700
White Bear Lake, MN 55110
USA
Phone 877-206-5800
Fax 651-762-4693
www.videofied.com
Flat Wall Mounting Holes
Corner Mounting Holes
I N S T A L L A T I O N I N S T R U C T I O N S
Camera Model DCV200/DCV600/DCV700
