When the TV is switched on for the first time it may default
to Analogue Tuner Mode (Standard TV) – To start Digital
Tuning you must switch the TV into DTV Mode.
6. Digital Tuning: First Installation
KEY CONTROLS
A – POWER KEY
B – DTV MENU
C – ARROW KEYS
D – SOURCE KEY
E – ENTER or OK KEY
F – ATV MENU
G – TV KEY
A
C
D
B
o
E
G
F
fig 1
1. Press the SOURCE key (D) on the remote control –
the source input menu appears on screen (fig 2) –
this will only remain on screen for a few seconds for
you to select your option – if the menu disappears
simply press the SOURCE key again to display.
2. Use the down
ARROW key (C) on the remote to
highlight the DTV option. Once highlighted press the
ENTER/ OK key (E)
First Installation
Remote Control Unit:
Ensure that the remote control is in
TV mode – press the TV key (G - fig 1) – the remote will now
operate the TV..
With the TV connected and switched on as described
previously follow the steps below to tune into Digital TV
broadcasts.
DIGITAL TV TUNING
fig 2
11
3. An onscreen message – “DTV Initial...” Appears
followed by a Welcome message – after a few
moments the “First Installation” screen (fig 3)
appears.
4. As per the On screen display - ensure your aerial is
connected to the TV – The country option should
default as “United Kingdom”– otherwise use the
right
ARROW key (C) to select “United Kingdom”
5. Press ENTER/ OK (E) – The TV will now auto-tune
displaying a progress bar and listing channels as they
are found (fig 4) – this will take a few moments to
complete. Once finished an “installation completed”
message will be displayed (fig 5).
6. After a few moments the TV will display a TV picture
(BBC1 usually) – and is ready to use – all done.
7. If the TV channels appear in an unusual order, or you
have TV channels missing, please perform a factory
reset on the TV and follow steps 3 – 6 again – for
instructions on how to do this please see the trouble
shooting section in this user guide book.
fig 2
United Kingdom
fig 5
fig 3
fig 4
Installation Complete