5.8GHz Day-Night Camera Series Manual Rev. A
3
SAFETY NOTICES
I.
THIS DEVICE COMPLIES WITH FCC RULES PART 15. OPERATION IS SUBJECT
TO THE FOLLOWING TWO CONDITONS:
(1)
This device may not cause harmful interference, and
(2)
This device must accept any interference, including interference that
may cause undesired operation of the device
II.
In order to comply with the FCC/IC adopted RF exposure requirements, this transmission
system will be installed by an authorized professional installer of VideoComm
Technologies. Installation of all antennas must be performed in a manner that will provide
at least 23cm clearance from the front radiating aperture, to any user or member of the
public.
III.
This is NOT an intrinsically safe device. Do not take into area where intrinsic safety is
required. Bodily harm may result if warning is ignored.
IV.
DO NOT OPERATE CAMERA WITHOUT ANTENNA CONNECTED TO ANTENNA
PORT. Failure to do so will result in damage to the unit and void the warranty.
V.
DO NOT OPERATE THE SYSTEM WHEN the Camera & Receiver are closer than ten
feet to each other. The devices may not work properly and permanent damage can occur.
VI.
This device has been certified by the FCC for use with other products without any further
certification (as per FCC section 2.1091.) Changes or modifications not expressly approved
by VideoComm Technologies could void the user’s authority to operate the equipment.
