Installation
VX-3000 Installation/Operation Manual
47
PRE
L
IMINAR
Y
6.
Select the Cinema or Virtual Cinema aspect ratio to move the anamorphic lens into
position, if it isn’t already. To do this, press
CINEMA
or
VCINE
on the VX-3000
remote control (Figure 2-4).
Adjusting the Horizontal (X) Lens Position:
1.
Project a white field on the screen.
2.
Loosen the Yaw/X-Adjustment Levers underneath the lens.
3.
Slowly move the anamorphic lens into place (from right to left or vice versa) so that
there are no shadows on either side of the screen:
4.
When the horizontal position is properly set, tighten the Yaw/X-Adjustment Levers to
secure the lens in place.
Adjusting the Height (Y):
With the white field still on-screen, loosen the
Height/Y Adjustment T-Screws on either side of the lens. Then, slowly move the
anamorphic lens into place so that there are no shadows on the top or bottom of the
screen:
When the height is properly set, tighten the Height Adjustment T-Screws to secure the
lens in place.
Too Far Right
Too Far Left
Correct position
Too High
Too Low
Correct position
Downloaded From projector-manual.com Runco Manuals
