Victron energy BlueSolar PWM DUO 12V 24V 20A LCD USB, Руководство пользователя

Страница: 6 / 75

4
Main display: battery1 voltage, battery state of charge, charging
status.
If arrow is flashing charger is in float.
By arrow of: no solar available.
Press MENU
to enter next display.
Change settings in
Main display.
Press the MENU
button for several
seconds until the
display flashes, you are
in:
Battery type setting.
See table below.
The factory setting is b01
Press on the MENU
key again and you
are in:
Charging Ratio of Battery 1
Current ratio to battery1
20% means 20% of available current
to battery 1 and 80% to Battery2
during Bulk phase.
The factory setting is 50%
Note:
In the normal charging status, the controller will divide the charging as the setting.
When battery #1 is fully charged, more charge current will go to battery #2.
When the controller detects that only battery #1 is connected, all the charge current will go
to the battery #1 automatically.
Press on the MENU
key again and you
are in:
Charging Frequency
Frequency switching between
Battery1 and Battery2: 25, 50 or
100Hz
The factory setting is 25Hz
Battery type Battery
voltage
Absorbtion
voltage
Float voltage Low voltage
disconnect
Low voltage
reconnect
b01
LEAD-ACID
[AGM]
12.0V [24V] 14.4V [28.8V] 13.7V [27.4V] 11.2V [22.4V] 12.6V [25.2V]
b02
LEAD-ACID
[Gel]
12.0V [24V] 14.2V [28.4V] 13.7V [27.4V] 11.2V [22.4V] 12.6V [25.2V]
b03
LEAD-ACID
[Wet]
12.0V [24V] 14.6V [29.2V] 13.7V [27.4V] 11.2V [22.4V] 12.6V [25.2V]
b04 LiFePO4 12.8V 14.2V 13.35V 11.2V 12.6V
b05 LiFePO4 25.6V 28.4V 26.7V 22.4V 25.2V