UNIVERSAL LEG SET & PANEL KIT
Thank you for purchasing our tray. Please fully read these installa on procedures and
familiarise yourself with the components before commencement.
Please inspect the product immediately and fully upon receipt and prior to installa on for transit
damage, or any defects. Damage or defects reported later cannot be accepted.
Your tray comes with a protec v
e fi
lm. Peel back to inspect then replace.
Do not discard the packaging as some
lised through out the installa on procedures.
Assembly of the Universal Leg Set & Panel Kit
For the best results & ease of installation determine the waste position of the tray.
Place the tray in the desired position or best location to simplify the installation.
The tray can be rotated indexing the waste to the most suitable position.
Fit the waste assembly & exit pipe work (following the waste manufacturers instruction & advice)
Place the tray face down on a protec ve surface or packaging.
See over the page and check your size & type of product.
Align the legs and panel clips to the diagram overleaf which suits your product.
Note! All trays 1400mm and above require x2 'easy plumb' leg kits.
Your tray is supported by a new reinforcement material with the ability to screw into.
Secure each leg with x3 (13mm) 1/2" x No8 round headed screws provided.
Under no circustances use a longer screw fo
ng into the base.
Adjust the leg so that the overall assembly is a 100mm to suit the panel loca on and lightly ghten
the hexagonal nut.
Depending on which leg clip has been supplied, screw the panel clips to the underside of the tray
as illustrated overleaf.
It is important that the correct screw size is used for this operation.
We recommend that the metal cli
p is fi
ed so that it overhangs the tray 4mm.
The plas c clip should
be fi
ed to suit the panel return depth as this may vary.
When moving your tray into position, do not slide as this can loosen the leg
ngs.
In most cases, your plas panel(s) is supplied over length.
Place onto the clips following the contour of the product if applicable.
Mark the panel to length at each end & cut accurately to length wit
h a fin
e toothed saw.
Remove the panel.
Turn over the tray & adjust the adjustable feet to level the tray. Fit the panel which is 100mm in
height into its desired loca on.
Check with a spirit level that the tray is correctly levelled and fully ghten the hexagonal nuts on
the legs.
Scribe a line on the
flo
or where the panel will sit.
Fit to the
flo
or behind the scribed line taking account of the panel return lip. Fit several small blocks
of wood (not supplied) to ensure the panel remains stable.
It is recommended that the legs at the front of the tray are screwed to the
flo
or.
Special care should be taken when using power tools & when drilling take care to avoid hidden
pipes or electrical cables.
Make all waste connec ons &
er ing seal the tray along the contact edges.
Check for water ghtness and
fin
ally
fi
t the panel(s)
