4
GANTRY (Where purchased)
Depending on your purchase of gantry or shelf you may have quartz heat lamps, these
are controlled by an on/off switch or dimmer switch located on the gantry or control
panel, which enables the lamps to be switched on or off or varied between. Quartz
lamps are replaceable. Please proceed as follows:
Lamps should be held using a piece of tissue wrapped around the bulb.
They must not be touched with fingers, as this will cause them to fail prematurely.
(a)
Turn off power to the unit.
(b)
Remove the lamp guard, by removing the retaining screw and hinging down.
(c)
Push the bulb to one side of the sprung loaded holder, hinge or lower the free
end and remove.
(d)
Reverse this process to fit, ensuring that the bulb is held firmly within the sprung
loaded holder.
TRAY SLIDE (Where purchased)
Your appliance may be fitted with a tray slide which can be either fixed or drop down. If
the drop down style has been purchased, it can be lowered to enable easy repositioning
of the unit. To lower the trayslide, proceed as follows:
(a)
Lift the tray rails up and then allow them to hinge down.
(b)
To replace, hinge up then lower vertically.
4. CLEANING
SWITCH OFF THE UNIT AT THE MAINS BEFORE CLEANING.
Stainless steel surfaces will give you many years of trouble-free use as long as you follow a
few simple rules. If it appears to mark do not worry, it is usually not the steel but
something deposited on it which has stained.
Do wash all surfaces before use. You should use a damp cloth and a mild detergent or
soap, or similar cleaner. Always rinse well with clean water and dry the surface with a
soft cloth. Clean regularly when in use. Do use soft cloths, nylon or bristle brushes.
Do not use metal scrapers, wire brushes or wire wool pads as they can scratch the steel.
Do take care when handling sharp objects as they can scratch the surface of stainless
steel. Any scratches on stainless steel will blend together over a period of time and
become less noticeable with age. There is no detriment to the corrosion resistance or
general performance of the material.
Do not use bleach for cleaning purposes (remember dishwasher powders, sterilising
agents and similar products all contain chlorides). If used, black pit marks, large brown
patches or other such effects may appear and permanent damage may be caused. If
used inadvertently rinse immediately with clean water.
Do not splash the unit with bleach when cleaning around the counter. If you do, rinse the
surface immediately with clean water thoroughly.
