Viconte VC-1469, Инструкция по эксплуатации

Страница: 4 / 18

3
v
Do not immerse the appliance in water or other liquids.
v
Do not use an appliance that has fallen into water. Unplug it immediately.
v
Use this appliance only for its intended use as described in this manual.
v
Do not use attachments not recommended by the manufacturer.
v
This appliance should never be left unattended when plugged in.
v
Close supervision is necessary when this appliance is used on, or near children or invalids.
v
Never operate this appliance if it has a damaged cord or plug, if it is not working properly.
v
Keep the cord away from heated surfaces.
v
Do not pull, twist, or wrap the power cord around appliance.
v
Never drop or insert any object into any opening of this appliance.
v
Before use, make certain of blades are aligned properly.
v
Do not place appliance on any surface while it is operating.
v
Do not use this appliance neither with a damaged or broken comb nor with teeth missing from the blades as injury
may occur.
NOTE: KEEP BLADES OILED.
BLADE ALIGNMENT
v
Your clippers were carefully examined to ensure that the blades were oiled and aligned be-
fore leaving our factory.
v
Blades must be realigned if they have been removed for cleaning or replacement.
v
To realign the blades, simply match the upper and
bottom blades teeth up, point for point.
v
End of top blade teeth should be approximately 1.2 mm back from bottom blade. Compare your clipper
blades with the sketch.
v
If blade alignment is incorrect, add a few drops of oil to the blades, switch on clipper for a few moments,
switch off and unplug. Loosen screws slightly and adjust. Tighten screws after blade is aligned.
OIL
v
To maintain your clipper in peak condition, the blades should be oiled every few haircuts.
v
Do not use hair oil, grease, oil mixed with kerosene or any solvent. As the solvent will evaporate and leave
the thick oil which may slow down the blades motion.