ZigBee Module Installation Guide
2
©
2
01
4 V
ic
onc
is
T
ec
hno
lo
gi
es
. A
ll r
ig
ht
s r
ese
rv
ed
.
Viconics Technologies Inc.
|
9245 Langelier Blvd.
|
St.-Leonard
|
Quebec
|
Canada
|
H1P 3K9
|
Tel: (514) 321-5660
|
Fax: (514) 321-4150
028-0425-01
www.viconics.com
|
November 2014
This guide shows you how to install the ZigBee Pro
wireless module with a VT8000 Series Room Controller.
1. Remove security screw on bottom of Room Controller
cover.
2. Open unit by pulling on bottom of Room Controller
(Figure 1).
3. Carefully remove Room Controllers Motherboard from
casing and turn over.
4. Locate gap in upper-right corner of Room Controllers
Motherboard and locate holes to insert ZigBee Pro
module to Motherboard (Figure 2).
5. Align connector pins on ZigBee Pro module with holes
on Motherboard.
NOTE
:
ensure alignment of pins is correct so as to not
damage ZigBee Pro module.
6. Gently press ZigBee Pro module into Room Controllers
Motherboard until it fits snugly in place.
NOTE
:
do not press too hard to avoid damage to ZigBee
Pro module.
7. Gently replace Room Controllers Motherboard into
casing.
8. Gently align cover to top of base and snap in place
from bottom (Figure 3).
9. Install security screw.
Figure-1
Figure-3
Figure-2
