20 |
028-0323-02_LIT-VZ7656R&VZ7656H_W-E01_EN
September 2019
I
NSTALLER
C
ONFIGURATION
P
ARAMETER
M
ENU
Configuration can be done through the network or locally at the Terminal Equipment
Controller.
To enter configuration, press and hold the middle button “Menu” for 8 seconds
If a password lockout is active, “Password” is prompted. Enter password value using the
“up” and “down” arrows and press “Yes” to gain access to all configuration properties of
the Terminal Equipment Controller. A wrong password entered will prevent local access to
the configuration menu.
Once in the configuration menu, press the “No” button repetitively to scroll between all the
available parameters.
When the desired parameter is displayed, press “Yes” to adjust it to the desired value
using “up” and “down” arrows. Once set, press “Yes” to scroll to the next parameter.
Configuration Parameters
Default Value
Significance and Adjustments
PswrdSet
Configuration parameters
menu access password
Default value =
0
No password prompted
This parameter sets a password access to prevent
unauthorized access to the configuration menu
parameters. A default value of “0” will not prompt a
password or lock the access to the configuration
menu.
Range is: 0 to 1000
RTC MAC
Zone Controller network
address
Default Value:
4
RTC MAC address must be unique for the entire
network.
1 to 255
(Increments: 1 or 10)
PAN ID
Personal Area Network
Identification
Default value = 0
Range is:
0 to 500
This parameter (Personal Area Network Identification) is
used to link specific controllers to a single specific
Viconics wireless gateway (VWG / Jace-Driver) or a
specific VZ76 RTU controller. For every controller
reporting to a VWG / Jace-Driver or VZ76 controller, be
sure you set the
SAME
PAN ID value.
The default value of 0 is
NOT
a valid PAN ID. The valid
range of available PAN ID is from 1 to 500.
