3
Viconics Technologies Inc.
|
9245 Langelier Blvd.
|
St.-Leonard
|
Quebec
|
Canada
|
H1P 3K9
|
Tel: (514) 321-5660
|
Fax: (514) 321-4150
028-0414-05
www.viconics.com
|
February 2018
INSTALLATION
Location
•
Do not install on outside wall.
•
Do not install in areas with direct heat source.
•
Do no install near any air discharge grill.
•
Do not install in areas exposed to direct sunlight.
•
Ensure Room Controller has sufficient air circulation.
•
Ensure wall surface is flat and clean.
Installation
1. Open unit by pulling on bottom side of Room Controller (Figure 1).
2. Read FCC ID and IC label installed in cover before installing any wireless
product.
3. Ensure correct side of base faces up.
4. Pull cables 6in (15cm) out from wall.
5. Align base and mark location of two mounting holes on wall (Figure 2).
6. Install anchors in wall.
7. Insert cable in central hole of base.
8. Insert screws in mounting holes on each side of base.
9. Strip each wire 1/4in ( 0.6cm) from end.
10. Insert each wire according to wiring chart (next page).
11. Gently push excess wiring back into hole.
12. Gently align cover to top of base and snap in place from bottom (Figure 3).
13. Install security screw.
• If replacing an existing Line Voltage FCU Controller, label the
wires before removal of the controller.
• Electronic controls are static sensitive devices. Discharge
yourself properly before manipulating and installing the
Room Controller.
• A short circuit or wrong wiring may permanently damage the
Room Controller or the equipment.
• All VTR8300 series Room Controllers are designed for
use as operating controls only and are not safety devices.
Tampering with the devices or unintended application of
the devices will result in a void of warranty. This transmitter
must be installed to provide a separation distance of at least
4in (10cm) from all persons and must not be collocated
or operating in conjunction with any other antenna or
transmitter.
Figure-1 Open the cover
Figure-2 Install the base
Figure-3 Reinstall cover
