028-0425-04_II-VT8000-VCM8000_A4_EN www.viconics.com
February 2020
Figure 3
Figure 2
Figure 1
2
VT8000
[
ZigBee Pro Module Installation Guide
]
Installation
This guide shows you how to install the ZigBee Pro
wireless module with a VT8000 Room Controller.
1. Remove the security screw from the bottom of
the Room Controller cover.
2. Open the unit by pulling on the bottom of the
Room Controller (Figure 1).
3. Carefully turn the Room Controller over to access
the motherboard.
4. Locate the gap in the upper-right corner of the
Room Controller’s motherboard, as well as the
holes indicating where to insert the ZigBee Pro
module into the motherboard (Figure 2).
5. Align the connector pins of the ZigBee Pro
module with the holes on the motherboard.
NOTE:
Ensure the pins are aligned correctly to
avoid damaging the ZigBee Pro module.
6. Gently press the ZigBee Pro module into the
Room Controller’s motherboard until it fits snugly
into place.
NOTE:
Do not press too hard to avoid damaging
the ZigBee Pro module.
7. Gently align the cover with the top of the base,
and snap it into place from the bottom (Figure 3).
8. Install the security screw.
